Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Lochwood
If your crown is cracked or your cap is rusted through, you’re losing your chimney to water one rainstorm at a time. Chimney cap and crown work in Lochwood is our trade, not a sideline, and it starts with a look at the top of the chimney, not a sales pitch. We answer 24/7 at (833) 508-9984, and our technicians have up to 8 years of experience with the mid-century ranches packed between the White Rock Lake shoreline and the tree-lined streets off Garland Road. Lochwood homes have their own patterns, and cap and crown work goes better when the person on the roof knows them.
Why Lochwood Homeowners Call Chimney Sweep Lake Highlands for Chimney Cap & Crown
Cap and crown problems in Lochwood don’t announce themselves. Water gets in slowly, the flue stays wet, and by the time you notice a stain, the damage has been working for a season or two. That’s why we start every job with camera inspection: we show you the photo of the cracked crown or the rusted-through cap before we recommend anything. You see the evidence yourself, and nothing gets sold that the camera can’t back up.
We handle the full scope here, from the firebox to the cap, which means a crown job doesn’t get handed off to a roofer or a handyman halfway through. Our technicians have up to 8 years of experience, and every one of them works on chimneys and nothing else. When we’re on a Lochwood roof, we’re looking at the same things your neighbors’ homes have: original clay tile flues, aftermarket gas log sets, and caps full of pecans leaves by November. We know what those combinations do over time.
We also work with materials the trade trusts, including Olympia Chimney caps, Famco products, and Copperfield supplies, so replacement parts match the chimney rather than getting forced onto it. Serving Lochwood means respecting its quirks, and that starts with showing up prepared for a 1950s flue rather than a new build.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Lochwood
Cap Installation
A properly sized cap keeps water, leaves, and animals out of the flue without choking the draft. On a Lochwood ranch with a wide masonry chimney, that usually means measuring the actual footprint rather than grabbing a stock size. We install caps from Olympia Chimney and Famco, and we build the fit around your chimney, not the other way around.

Cap Replacement
Standard caps rust out faster in Lochwood than most homeowners expect, because the pecan and oak canopy dumps leaves and twigs onto the mesh every fall. Wet debris sits on the screen and the metal gives up within a few seasons. We swap a failing cap for one sized and anchored correctly, and we clear the debris that’s been collecting underneath.

Crown Repair
The crown is the concrete top of the chimney, and it’s the first thing North Texas heat and the occasional hard winter ice event crack. On the 1950s and 60s ranches around Lochwood, hairline cracks in an original crown let water straight into the clay tile flue below. We remove the failed crown, pour a new one with the right overhang and drip edge, and tie the flashing in so water runs off instead of in.

Crown Coating
Not every crown needs to come off. When the damage is surface-level spalling and the crown is still structurally sound, a coating can seal it and buy years. A crown coating makes sense on a crown that’s still solid. We’ll tell you plainly when it will solve the problem and when it’s just delaying the pour.
Trusted Brands We Service in Lochwood
We work with professional-grade product lines the chimney trade actually uses: Olympia Chimney components for caps and dampers, Famco cap products, Copperfield supplies, and DuraFlex liner systems for relining when the inspection calls for it. If you already have a cap or chase cover from one of these makers, we can work with what’s there rather than pushing a full replacement. We don’t stock parts on a truck or keep a warehouse; we source what the job needs and schedule the work so it goes on in one visit where possible. That keeps a simple cap swap from turning into a two-week project.
Common Chimney Cap & Crown Problems We See in Lochwood Homes
- Cracked original crowns. Decade after decade of heating and cooling cycles cracks the poured crown on the original ranch chimneys, and a missing drip edge lets water run down the masonry face instead of off the edge.
- Clogged caps under the canopy. The mature pecan and oak stands above most of Lochwood drop leaves and twigs every fall, and a standard mesh cap fills up fast. Once it’s packed, the draft suffers and the screen starts to corrode.
- Unlined gas-log retrofits. Many Lochwood fireplaces were converted to gas logs or inserts without a proper liner, and the original 1950s clay tile flue wasn’t built for that heat cycle. It cracks, and the crack is often only visible on a Level 2 inspection.
- Storm-damaged crowns. Spring storms in this part of East Dallas can spall a crown that was already thinning, especially ones that never had proper flashing to begin with. A cracked crown is the most common way water gets into a Lochwood chimney.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Lochwood, TX
Cap and crown work here runs on the middle of the North Texas market, and the size of the chimney drives most of it. A typical single-flue cap installation in Lochwood runs $250 – $550 depending on cap type and chimney size. A multi-flue cap for a wide ranch chimney usually runs $450 – $850. Crown repair, where a failed crown is removed and a new one poured and flashed, typically runs $600 – $1,400. A crown coating over a sound crown is the smaller job, usually $300 – $600.
Prices are estimates, and the written estimate sets the final price. There’s no charge for the estimate, and we won’t recommend a full rebuild when a coating will hold. We show you the camera photo before we quote it.
We Also Serve Cities Near Lochwood
We cover the neighborhoods around white rock and the surrounding East Dallas pockets, and cap and crown work in Lochwood is part of the larger service area. That includes Forest Hills, White Rock, Casa View, and Lakewood, where the housing stock and tree cover create many of the same crown and cap problems. If you’re just outside Lochwood, call and we’ll confirm coverage.
If you want the full picture of what we do on caps and crowns, our chimney cap & crown page covers the service in detail.
Serving Lochwood, TX – Our Local Coverage Area
We serve Lochwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Lochwood
Once a year, and that’s the honest minimum for a chimney you actually burn in. Lochwood fireplaces sit idle through the long hot months, which lets soot and creosote accumulate and moisture settle in, so an annual inspection catches problems before the first fire of the season. Call (833) 508-9984 for an exact quote; estimates are free.
The typical fix is a new cast-in-place crown with proper overhang and flashing, plus a correctly sized replacement cap. That’s the pattern on most Lochwood ranches: the cracked crown lets water in, and a cap that’s rusted from trapped leaves and twigs stops keeping it out. Call (833) 508-9984 for an exact quote after we see the chimney; estimates are free.
The mature pecan and oak canopy over the neighborhood drops leaves and twigs straight onto the caps every fall, and a standard mesh screen packs up fast. Once the cap is clogged, the draft drops and the screen holds moisture, which speeds corrosion. A custom or multi-flue cap sized to the chimney handles the debris load better. Call (833) 508-9984 for an exact quote; estimates are free.
A coating can fix it when the crown is still structurally sound and the damage is surface spalling. If the crown has deeper cracks or has separated from the flue, a coating just hides the problem and water keeps getting in. We tell you which one you need after we’re on the roof. Call (833) 508-9984 for an exact quote; estimates are free.
A multi-flue cap covers more than one flue on a single chimney with one housing; a custom cap is built to the exact footprint of your chimney, single flue or multi. On the wide masonry chimneys common in Lochwood’s ranches, multi-flue is the usual answer, but a custom cap fits better on an irregular footprint. Call (833) 508-9984 for an exact quote; estimates are free.
What Happens When You Call
We answer 24/7 at (833) 508-9984, and we book cap and crown work with fast dispatch from 7am to 7pm, Sunday through Friday. There’s no charge for the estimate, and nothing gets recommended without a camera photo you can see yourself. If your crown can safely wait a season, we’ll say so. Call (833) 508-9984 for a free estimate.
Written by the team at Chimney Sweep Lake Highlands.